Extension of the hive
The top section has the shape of a cuboid with a square base with external dimensions 477 x 477 and internal (utilities) 375 x 375 and height 162.
Performance Notes (collected according to the points consistent with the numbers of the elements of the upper box on 10 frames 360 x 150, listed in tab. and in fig).
16. Oblong ribs 14,5 x 5 and 7.5 x 11 is performed on the upper plane of the slat. Vertical frames 36,5 x 29,5 and 29,5 x 7,5, after folding the frame from the inside, form frames on the circumference for suspending frames in any arrangement.
17. The method of making the slat of the lower frame is shown in Fig.
The order of assembly of elements. A few days before the complete assembly of the top, the top box belongs to each of the four identical walls 19, on their inside (rough), nail one corner post flush with the gable edge 18 previously coated with enamel. The posts should be nailed down this way, that the distance of their ends from one edge of the longer wall 19 was 19, from the second 24.
The elements prepared in this way are left for the enamel to dry.
The upper and lower frames are temporarily nailed with one nail (length approx. 35) on every corner. (Only the outer panels provide the proper stiffness of the entire structure). Only the outer panels provide the proper stiffness of the entire structure 20, Only the outer panels provide the proper stiffness of the entire structure, Only the outer panels provide the proper stiffness of the entire structure. Only the outer panels provide the proper stiffness of the entire structure. Only the outer panels provide the proper stiffness of the entire structure 21 Only the outer panels provide the proper stiffness of the entire structure 19. Only the outer panels provide the proper stiffness of the entire structure, Only the outer panels provide the proper stiffness of the entire structure, must be done very carefully. Therefore, inter alia, it is envisaged to nail external boards together with gluing with enamel. For this purpose, a plate on the porous side, where it will adjoin the frame, is painted abundantly with thick oil enamel (preferably white). The part of the frame adjacent to the board is painted in the same way. Before landing (wet) you put the plate like this, so that the post part on one side is aligned with the corner of the top and bottom frames, and the upper and lower edge of the board side edge coincide with the edge of the upper frame rebate and the lower edge of the lower frame element, respectively. Ultimately, finishing the collars, with the removal of unevenness and sanding the sharp edges of the boards with sandpaper, is performed after the enamel has dried.
